Glossary termStatics
line of thrust
Stützlinie
The locus of the points where the resultant force crosses successive joints of an arch, vault or abutment. Masonry is stable if a line of thrust in equilibrium with the loads fits within the section.
Note on the evidence Ungewitter uses both words: 'Stützlinie' mostly for vaults, 'Drucklinie' for abutments (02-abutments §1). Modern literature sometimes distinguishes the line of thrust (locus of the points where the resultants cross the joints) from the line of resultants (the funicular polygon of their lines of action); the book uses the words as synonyms, and so does this glossary.
Names
- English
- line of thrust also line of pressure (Ricker), thrust line, pressure line
- German
- Stützlinie also Drucklinie, Mittellinie des Druckes
- French
- ligne des pressions / courbe des pressions
Sources
Related terms
Used in
Lessons
- Lesson 1: Why arches stand
- Lesson 2: Pointed or round?
- Lesson 5: Holding back the thrust
- Lesson 6: The flying buttress
- Lesson 10: Rules of thumb across the centuries
- Lesson 13: How safe is safe? Heyman’s geometric factor
- Lesson 14: The cracked buttress
- Lesson 15: The flyer’s range of thrust
- Lesson 19: Thrust networks
- Lesson 22: Cutting the stone
Rules that mention it
- Sizing by tracing the line of pressure
- Line of thrust through the abutment
- Crown load for slender pointed arches
- Pressure on a joint
- The pointed arch follows the line of thrust
- Line of thrust in the middle third
- An arch stands while a line of thrust fits
- Line of thrust (Stützlinie)
- The most favourable line of thrust
- How high the buttress must rise
- Benchmark: thinnest semicircular arch
- Angle between the thrust and the joint normal
- Geometric factor of safety
- Collapse mechanism of an arch
- Minimum thickness of an arch
- 1890 against modern statics
- The arch on spreading supports
- The safe theorem of masonry
- Target factor of a buttress, cracked
- Both verdicts on every support
- Joint factor of piers and clerestory walls
- Geometric factor of a vault, read on its equivalent arch
- End forces of a flying buttress
- Middle-third (kern) rule
- Line of pressure through an abutment, course by course
- Buttress courses and set-offs
- Buttress depth from the statics
- Section and elevation of the design
- Storm as a rare load
- The pointed diagonal is the norm