Skip to content
Ungewitter

RuleModern statics

The leaning buttress

modern.kinematics.leaning-buttress

documentedimplementedModern

Stated in a medieval text.

Statement

Most buttresses lean outward a little, from settlement, creep and the slow ratcheting of their stones; typical leans are under 2°. Leaning about its outer toe by a small angle φ shifts the buttress’s weight toward the toe, so its restoring moment, and with it the thrust it can resist, falls in proportion to φ. For a cracked rectangular buttress the fracture height barely changes as it leans, so the fracture of the upright buttress can be kept: the capacity falls from H_u by b·h_b·γ·φ(ψ + 1/(2μ)), a little less if the lost wedge below the fracture is counted, and it would vanish at the lean φ_max. The springing moves out by h·φ: a buttress 10 m high leaning 1° widens the span of its arch by 0.17 m.

Formula

Hϕ=Hu−b2γϕhbb(ψ+12μ−μξ26),ϕmax⁡=(1+2ψ)/(2μ)−ξ/3(hb/b)(ψ+1/(2μ))

Parameters

validation_goa.width_m
2.7
validation_goa.height_m
13.4
validation_goa.thrust_height_m
12.5
validation_goa.vertical_kN
64
validation_goa.unit_weight_kN_m3
25
validation_goa.loss_per_degree_kN
10
validation_goa.capacity_at_0_4_deg_kN
65
validation_goa.source_page
132
engine
eq. 4.10 gives 9.6 kN per degree and 65.0 kN at 0.4°; eq. 4.9 (with the wedge) 8.4 kN per degree
fracture_height
eq. 4.7 equals eq. 3.25 at φ = 0 and moves by less than 0.04 up to 2° for h_b/b 4 and 6, μ 0.5 and 0.7, ψ 0.1 to 1 (Figs. 4.3–4.4)

Modern note

Read in the thesis, chapter 4. The printed eq. 4.2 lacks a factor h/b on V in its φ term; eqs. 4.5–4.11 are consistent and are the ones used. The monolithic block (eq. 4.1) is given for comparison. Small angles throughout, as in the source.

Sources

Where implemented

@ungewitter/statics#leaningCapacity, leaningFractureHeight

Tools in this area

Terms