Skip to content
Ungewitter

RuleModern statics

The cracked buttress

modern.buttress.cracked

documentedimplementedModern

Stated in a medieval text.

Statement

A buttress of many stones has no tensile strength across its joints, so it does not overturn as one block. At collapse a fracture runs from the outer toe up to the inner face, and the lower inner wedge stays behind; only the part outside the fracture rotates, and the weight of the wedge no longer helps (Ochsendorf 2002, ch. 3; Ochsendorf, Hernando & Huerta 2004). Assuming a linear distribution of compression, the resultant in the fractured zone acts at the third point of the compressed width, and the fracture is then a straight line from the toe to the inner face at height e. Two conditions fix e and the collapse load: the moments of the rotating part about the toe, and the equilibrium of the compressed triangle below e with its resultant at a third of the width. For a rectangular buttress they give a quadratic for e, and the capacity falls by 20–30 % for usual proportions, by up to two thirds for a bare buttress pushed at its top. The engine finds e as the lowest fracture at which the rotating part needs no further cracking (its resultant in the kern of its own section below e); for rectangles this is the published model exactly, and for stepped and T-shaped sections it is the generalisation the thesis sketches.

Formula

2μξ2−(3+6ψ+μ)ξ+2(1+ψ)=0,Hu=bh(Wb2+V−γbe3),ξ=eh, μ=hhb, ψ=VWb

Parameters

validation_rectangle.width_m
3
validation_rectangle.height_m
12
validation_rectangle.thrust_height_m
8
validation_rectangle.depth_density_kN_m2
29.4
validation_rectangle.vertical_kN
100
validation_rectangle.solid_kN
234
validation_rectangle.fractured_kN
178
validation_rectangle.fracture_height_m
5.2
validation_rectangle.source_page
44
validation_goa.width_m
2.7
validation_goa.height_m
13.4
validation_goa.unit_weight_kN_m3
25
validation_goa.vertical_kN
64
validation_goa.thrust_height_m
12.5
validation_goa.monolithic_kN
112
validation_goa.fractured_kN
69
validation_goa.fracture_height_m
8.7
validation_goa.source_page
132
engine_vs_closed_form
relative difference < 1e-4 over b 0.5–5 m, h_b/b 1–12, μ 0.2–1, ψ 0–1.5 (property test)

Modern note

Read in Ochsendorf’s open-access thesis (chapter 3, eqs. 3.1–3.26, Figs. 3.4–3.8): the straight fracture, the two conditions and the quadratic for rectangles. The engine’s criterion, first reconstructed from the Goa example alone, turned out to be the same model; it now agrees with the closed form to 1e-5 and reproduces both worked examples (178 kN at e = 5.2 m; 69 kN at e = 8.7 m). The reduction depends only on μ and ψ, not on the width.

Sources

Where implemented

@ungewitter/statics#overturning, ochsendorfRectangular

Tools in this area

Terms