RuleMouldings
Buttress caps and their cornices
moulding.buttress-cap
Stated in a 19th-century treatise, above all the Lehrbuch of 1890.
Statement
The simplest cap is a pent slope against the wall: horizontal bed joints need a steeper slope, joints square to the slope allow a flatter one but need square-bonded end stones. The cornice may wrap the sides; a raking cornice may run along the cap edge and meet the horizontal one by turning horizontal (the simplest way to keep the profile), by interpenetration, or by dying on a neutral body (horns, head, leaf, later a corbelled pinnacle). A gable over the front or a saddle or hip cap leads the water to the corners; a raised raking cornice makes water pockets that need spouts. Ridges are strengthened by a roll, which seen from the front is the simplest crowning.
Sources
Ungewitter 1892, p. 448 (scan), Fig. 1037, 1038
Ungewitter 1892, p. 449 (scan), Fig. 1039, 1040, 1041, 1042, 1043, 1044, 1045
„Zu einer völligen Regelung des Wasserablaufs über die Ecken ist ferner sehr förderlich eine Erhöhung der Giebelsimse über die Dachfläche“
“A raising of the raking cornices above the roof face is further very helpful to regulate fully the flow of water over the corners”
Ungewitter 1892, p. 450 (scan), Fig. 1046, 1047
Ungewitter 1892, p. 451 (scan), Fig. 1048
Where implemented
Not implemented yet.