RulePortals
Brick portals
portal.brick
Stated in a 19th-century treatise, above all the Lehrbuch of 1890.
Statement
Early brick churches built rich portals wholly in stone (Riga), then moulded-brick steps with stone columns, capitals, bases and rolls (Seehausen), or only plinths and capitals in stone. Because brick courses are small, two arch rings stand on one capital where possible. Every stone piece bonded into brickwork gets a rectangular tail circumscribing its largest dimensions, so brick courses meet vertical joints and never mouldings. All-brick portals first set columns of round brick drums without bond, then bonded tailed column bricks alternately sideways and in depth; columns and rolls are half a brick (14 to 15 cm) or a third (9 to 11 cm). Profiles grow deeply undercut, columns recede, capitals lose weight; small doors stand on a plain granite block with profiles running on into the arch. Brick gables are best plain, edged by a projecting rowlock course or stepped, or replaced by a rectangular frame of the returned sill course.
Parameters
- stages
- stoneInBrick, stoneColumnsBrickSteps, stonePlinthsCapitals, allBrick
- ringsPerCapital
- 2
- column_cm.halfStein
- 14 – 15
- column_cm.thirdStein
- 9 – 11
- glaze
- black, brown, green, yellow
Sources
„dass womöglich 2 Bogenschichten ... auf ein Kapitäl zu stehen kommen“
“that where possible two arch rings come to stand on one capital”
Ungewitter 1892, p. 561 (scan), Fig. 1318, 1319
„Der Durchmesser solcher Säulchen oder Stäbe betrug meist ½ Stein also 14 bis 15 cm, doch kamen auch geringere Stärken von 9—11 cm (⅓ Stein) oft vor.“
“The diameter of such columns or rolls was mostly half a brick, that is 14 to 15 cm, but smaller sizes of 9 to 11 cm (a third of a brick) were also common.”
Ungewitter 1892, p. 562 (scan), Fig. 1320, 1321, 1322, 1322a, 1323, 1324
Where implemented
Not implemented yet.