Skip to content
Ungewitter

RuleMouldings

Main cornice: the type profile of Fig. 992

moulding.cornice

treatiseimplementedUngewitter 1890 (Mohrmann)

Stated in a 19th-century treatise, above all the Lehrbuch of 1890.

Statement

The commonest eaves cornice is a 45° slope from which a hollow is worked, under a vertical plate that lifts it out of the roof-edge shadow; the plate is often as high as the projection. On the slope ab the hanging lip ac, the hollow chord ce and the lower chamfer eb satisfy ac + eb = ce with ac : eb about 5 : 3, i.e. 5 : 8 : 3; ac is at least a quarter of ab. The hollow must not cut behind the wall face. Variants: rounding or roll instead of eb, two upper chamfers, a second drip below, two stones each with its own profile, or a leaf-filled hollow carrying a gutter stone.

Formula

hPlatte=P, H=P, α=45∘;ac:ce:eb=5:8:3, ac≥14ab

Parameters

hollow_radius_P
0.36
hollow_sweep_deg
200
hollow_note
measured off Fig. 992

Sources

  • „Die Höhe dieser Platte ist häufig der Ausladung des Gesimses gleich, also nach Fig. 992 gebildet“
    “The height of this plate is often equal to the projection of the cornice, i.e. formed as in Fig. 992”

    Ungewitter 1892, p. 438 (scan), Fig. 990, 991, 992

  • „Ein wolthuendes Verhältnis entsteht, wenn ac + eb = ce ist und ac sich zu eb etwa wie 5 : 3 verhält“
    “A pleasing proportion results when ac + eb = ce and ac is to eb about as 5 : 3”

    Ungewitter 1892, p. 439 (scan), Fig. 992, 992a, 992b, 993

  • Ungewitter 1892, p. 440 (scan), Fig. 997, 998, 999, 1000, 1001, 1002

Where implemented

@ungewitter/gothic#courseProfile

Tools in this area

Terms