Toledo Cathedral
Toledo · Catedral Primada Santa María de Toledo · Kathedrale von Toledo · Wikidata Q1123180
7 measured · 3 published · 7 provisional
A five-aisled cathedral on the model of Bourges, begun 1226, with a stepped section and a double ambulatory of alternating rectangular and triangular bays; the transept does not project beyond the aisles. Its vault height is given as 44.5 m (fr, en) and as 40 m (de).
Facts
- Main building campaign
- 1226–1493 provisionales Wikipedia, revision 176162238Begun 1226 under Ferdinand III; west nave vaults closed 1493.
- Plan type
- Basilica, 5 vessels, with transept provisionalde Wikipedia, revision 272094646Five-aisled, heights stepped from outer aisle to nave; modelled on Bourges.
- Material
- stone provisionalen Wikipedia, revision 1380962616en: white limestone from Olihuelas.
- Choir ending
- 5/8: 5 sides of a 8-sided polygon publishedDehio & von Bezold, Tafel 511, Fig. 2
- Towers
- Single north-west tower, 92 m (es/en) or 90 m (de/fr); south tower never finished. provisionales Wikipedia, revision 176162238
- Vaults
- Nave: quadripartite publishedDehio & von Bezold, Tafel 511, Fig. 2Star vaults over the crossing and the presbytery.
- East end
- a double ambulatory with 6 radiating chapels provisionalDehio & von Bezold, Tafel 511, Fig. 2A double ambulatory; the plan shows four small and two large chapels, many later rebuilt.
- Towers in plan
- two west towers provisionales Wikipedia, revision 176162238Laid out for two west towers; the north-west tower was built, the south one became the Mozarabic chapel.
- Flying buttresses
- 2 tiers, one above the other publishedDehio & von Bezold, Tafel 524, Fig. 1Two stacked flyers over the inner aisle to an intermediate pier, and one lower flyer over the outer aisle.
- Five-aisle system
- heights stepped down to the outer aisles (p. 289) publishedDehio & von Bezold, Tafel 524, Fig. 1Read on the section: nave, inner and outer aisles step down, the inner aisle with a clerestory of its own, after Bourges.
Dimensions
| Dimensions | Value | Convention | Source |
|---|---|---|---|
| Nave width | 14.14 m ± 0.1 mNave piers, axis to axis | axis to axismeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3540, 3248.5) to (3540, 3671) px; scale 40 m = 1195.6 px |
| Aisle widths | 8.95 m ± 0.1 mInner north aisle, pier axis to pier axis | axis to axismeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3540, 2981) to (3540, 3248.5) px; scale 40 m = 1195.6 px |
| 9.95 m ± 0.1 mOuter north aisle, pier axis to the line of the chapel openings | axis to axismeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3540, 2683.5) to (3540, 2981) px; scale 40 m = 1195.6 px | |
| Bay length | 7.61 m ± 0.05 mNave pier axes over 3 bays | axis to axismeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3321.5, 3669) to (4003.5, 3669) px; scale 40 m = 1195.6 px · over 3 bays |
| Nave vault height | 44.5 m | to the crownprovisional | fr Wikipedia, revision 241188983 Height under the vault of the central vessel 44.50 m. Other figures
|
| Piers | 2.44 m ± 0.1 mNave pier across the shafts, without the octagonal plinth, transverse | overallmeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3540, 3213.5) to (3540, 3286.5) px; scale 40 m = 1195.6 px |
| Buttress depths | 4.48 m ± 0.1 mInternal buttress (north), outer face to the line of the chapel openings | overallmeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3780, 2549.5) to (3780, 2683.5) px; scale 40 m = 1195.6 px |
| Wall thicknesses | 1.24 m ± 0.1 mOuter wall of the north chapels | overallmeasured | Dehio & von Bezold, Tafel 511, Fig. 2measured from (3620, 2551.5) to (3620, 2588.5) px; scale 40 m = 1195.6 px |
The design in plan
One bay in plan, to scale
As a design
The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave quadripartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.
Measured against the 1890 statics and the modern check
The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.
| Quantity | Building, measured | Ungewitter 1890, statics | Modern check (Heyman) |
|---|---|---|---|
| Depth of wall and buttress | 4.48 m measured | 3.79 m | 3.79 m |
| Building ÷ this depth | – | 1.18 | 1.18 |
| Kern rule of 1890 | kern left in the storm only (with wind from the left) | kern left in the storm only (with wind from the left) | kern left in the storm only (with wind from the left) |
| Geometric factor, cracked | 1.36 against 1: safe | 1.16 against 1: safe | 1.16 against 1: safe |
| Pier (1890 plan rule) | 2.44 m | 1.92 m | – |
| Wall between the buttresses (1890 plan rule) | 1.24 m | 1.3 m | – |
Forces at the springing of the nave vault, 36.66 m above the floor.
Why they differ
- The building is deeper than the statics asks. Its buttresses stand at the foot of 2 tiers of flyers: they had to give the flyers room, carry their thrust at its height and stand during building, before the vaults were closed. The kern rule asks only what the finished bay needs.
- The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.
Ungewitter’s rules against this building
The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.
In a basilica the nave vault is abutted through the flying buttresses by the whole system: aisles and outer buttress together. Ungewitter’s single-span rules were never meant for it, which is the point of the comparison.
Nave vault: span 11.7 m, springing at 36.7 m
| Rule | Filled in | Rule says | Building has | Building ÷ rule |
|---|---|---|---|---|
| Mohrmann, rule 5 | D = (0.222 · 11.7 m + 0.05 · 36.7 m) · 0.883 = 3.92 m | 3.92 m | 22.16 m | 5.66 |
| Hoffstadt | D = 11.7 m / 10 + √2 · 11.7 m / 10 = 2.82 m | 2.82 m | 22.16 m | 7.85 |
| Viollet-le-Duc | D = 8.13 m · (1 − cos(2 · 73.7 ° / 3)) = 2.81 m | 2.81 m | 22.16 m | 7.88 |
| Hase | D = 2.81 m + 0.15 m · 36.7 m / 4.5 m = 4.03 m | 4.03 m | 22.16 m | 5.49 |
| Earlier editions | D = (8.13 m + 0.3 m) / cos(37.2 °) − 8.13 m = 2.45 m | 2.45 m | 22.16 m | 9.05 |
Building has: whole abutment system: aisles + buttress, from the nave pier’s face
No aisle vault height is known, so the aisle vault is not checked.
Assumptions
- Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
- Heavy stone; no help from the walls between the buttresses.
The modern check: Heyman’s geometric factor
The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?
The buttress holds the estimated thrust, but cracked its geometric factor is only 1.51.
| Quantity | Value |
|---|---|
| Vault thrust per bay (estimate, Table I) | 52 kN |
| Height of the thrust (springing) | 36.7 m |
| Buttress depth (measured) | 4.48 m |
| Buttress breadth (assumed: half the depth) | 2.24 m |
| Thrust it holds: block | cracked | 539 | 180 kN |
| Minimum depth: block | cracked | 2.06 | 2.97 m |
| GSF on depth: block | cracked | 2.18 | 1.51 |
| Fracture height | 36.7 m |
| 1890: base joint, eccentricity ÷ kern | 0.29 |
Assumptions
- Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
- In a basilica the outer buttress takes the nave vault’s thrust through the flyers; the aisle vault is left out.
- Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).
Plates
Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.
Sources
Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.
Wikipedia contributors. 2026. Articles on Gothic churches in the Spanish, Catalan, Italian, Czech and English Wikipedias. Accessed November 21, 2026.
Numbers only, each with its article revision. Prose may not be copied (CC BY-SA share-alike).
Wikipedia contributors. 2026. Dimension lists in German and French Wikipedia articles on Gothic cathedrals. Accessed November 21, 2026.
Numbers only, each with its traced book citation. Prose may not be copied (CC BY-SA share-alike).
Dehio, Georg, and Gustav von Bezold. 1887–1901. Die kirchliche Baukunst des Abendlandes: Atlas. 5 vols. Stuttgart: Cotta.
Universitätsbibliothek Heidelberg (requested in the IIIF manifest)