Skip to content
Ungewitter

← All reference buildings

Soissons Cathedral

Soissons · Cathédrale Saint-Gervais-et-Saint-Protais de Soissons · Kathedrale von Soissons · Wikidata Q1736223

6 measured · 5 published · 6 provisional

A High Gothic basilica of the Chartres generation without galleries, begun with the choir about 1197; the round-ended south transept arm is older. The fr dimension list gives 11.5 m for the central vessel and 21.5 m in all, which adds up only if the widths are bay sizes between axes.

Facts

Main building campaign
1197–1230 provisionalfr Wikipedia, revision 241397957Choir 1197-1212 (begun c. 1190s), nave 1212-1230; south transept from 1176 is older.
Plan type
Basilica, 3 vessels, with transept provisionalfr Wikipedia, revision 241397957Nave with north and south aisles, three-storey elevation without galleries.
Material
stone provisionalfr Wikipedia, revision 241397957fr: Lutetian limestone of the Soissonnais.
Nave bays
7 provisionalfr Wikipedia, revision 241397957Seven nave bays plus one narthex bay; oblong quadripartite vaults.
Choir ending
5/10: 5 sides of a 10-sided polygon publishedDehio & von Bezold, Tafel 361, Fig. 2A polygon of five equal sides.
Towers
Single (south-west) facade tower 66 m. provisionalfr Wikipedia, revision 241397957
Vaults
Nave: quadripartite publishedDehio & von Bezold, Tafel 361, Fig. 2
East end
an ambulatory with 5 radiating chapels publishedDehio & von Bezold, Tafel 361, Fig. 2Five shallow chapels under the vaults of the ambulatory.
Towers in plan
two west towers publishedDehio & von Bezold, Tafel 361, Fig. 2The plan draws two west towers; only the south-west tower was built.
Flying buttresses
2 tiers, one above the other publishedDehio & von Bezold, Tafel 383, Fig. 2

Dimensions

DimensionsValueConventionSource
Nave width12.55 m ± 0.2 mNave piers, axis to axisaxis to axismeasuredDehio & von Bezold, Tafel 361, Fig. 2measured from (1582, 1220) to (1740.5, 1220) px; scale 30 m = 379 px
Other figures
Aisle widths5.66 m ± 0.2 mWest aisle, pier axis to inner face of the wallaxis to axismeasuredDehio & von Bezold, Tafel 361, Fig. 2measured from (1510.5, 1160) to (1582, 1160) px; scale 30 m = 379 px
Other figures
Bay length6.32 m ± 0.05 mNave pier axes over 5 baysaxis to axismeasuredDehio & von Bezold, Tafel 361, Fig. 2measured from (1581, 982) to (1581, 1381) px; scale 30 m = 379 px · over 5 bays
Other figures
Nave vault height31 mto the crownprovisionalfr Wikipedia, revision 241397957

Height under the vault of the choir; fr gives no separate nave figure.

Piers1.5 m ± 0.2 mNave pier (column with shafts), transverseoverallmeasuredDehio & von Bezold, Tafel 361, Fig. 2measured from (1572.5, 1220) to (1591.5, 1220) px; scale 30 m = 379 px
Buttress depths3.4 m ± 0.2 mNave buttress, outer face to inner face of the aisle walloverallmeasuredDehio & von Bezold, Tafel 361, Fig. 2measured from (1467.5, 1220) to (1510.5, 1220) px; scale 30 m = 379 px
Wall thicknesses1.03 m ± 0.2 mAisle wall beside the buttress (the window zone is drawn open)overallmeasuredDehio & von Bezold, Tafel 361, Fig. 2measured from (1497.5, 1160) to (1510.5, 1160) px; scale 30 m = 379 px

The design in plan

Plan of the design made from Soissons Cathedral: quadripartite nave vaults, an ambulatory with 5 radiating chapels.010 m
The Studio design made from the values on this page, drawn by the Studio’s own generators: cut masonry black, vault ribs dashed overhead. It is a design after the building, not a survey of it. The east end comes from the chevet generator (Ch. VI), which draws the church with one aisle on each side.

One bay in plan, to scale

Plan of one bay of Soissons Cathedral: nave 12.55 m between pier axes, buttress depth 3.4 m; dashed outline of Amiens Cathedral for comparison.12.55 m3.4 m010 m
Drawn from the values above: nave piers, aisles, outer wall and buttresses of one bay. Buttress breadth is schematic. The dashed outline is Amiens Cathedral at the same scale.

As a design

The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave quadripartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.

Measured against the 1890 statics and the modern check

The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.

Measured against the 1890 statics and the modern check
QuantityBuilding, measuredUngewitter 1890, staticsModern check (Heyman)
Depth of wall and buttress3.4 m measured2.52 m2.68 m
Building ÷ this depth–1.351.27
Kern rule of 1890kern left in the storm only (with wind from the left)kern left in the storm only (with wind from the left)kern left in the storm only (with wind from the left)
Geometric factor, cracked1.22 against 1: safe0.94 against 1: fails1 against 1: safe
Pier (1890 plan rule)1.5 m1.7 m–
Wall between the buttresses (1890 plan rule)1.03 m1.23 m–

Forces at the springing of the nave vault, 23.6 m above the floor.

Why they differ

  • The building is deeper than the statics asks. Its buttresses stand at the foot of 2 tiers of flyers: they had to give the flyers room, carry their thrust at its height and stand during building, before the vaults were closed. The kern rule asks only what the finished bay needs.
  • The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.

Ungewitter’s rules against this building

The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.

In a basilica the nave vault is abutted through the flying buttresses by the whole system: aisles and outer buttress together. Ungewitter’s single-span rules were never meant for it, which is the point of the comparison.

Nave vault: span 11.05 m, springing at 23.63 m

RuleFilled inRule saysBuilding hasBuilding ÷ rule
Mohrmann, rule 5D = (0.222 · 11.05 m + 0.05 · 23.63 m) · 0.866 = 3.15 m3.15 m8.31 m2.64
HoffstadtD = 11.05 m / 10 + √2 · 11.05 m / 10 = 2.67 m2.67 m8.31 m3.12
Viollet-le-DucD = 7.67 m · (1 − cos(2 · 73.7 ° / 3)) = 2.66 m2.66 m8.31 m3.13
HaseD = 2.66 m + 0.15 m · 23.63 m / 4.5 m = 3.44 m3.44 m8.31 m2.41
Earlier editionsD = (7.67 m + 0.3 m) / cos(37.2 °) − 7.67 m = 2.33 m2.33 m8.31 m3.56

Building has: whole abutment system: aisles + buttress, from the nave pier’s face

No aisle vault height is known, so the aisle vault is not checked.

Assumptions

  • Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
  • Heavy stone; no help from the walls between the buttresses.

The modern check: Heyman’s geometric factor

The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?

The buttress holds the estimated thrust, but cracked its geometric factor is only 1.24.

QuantityValue
Vault thrust per bay (estimate, Table I)41 kN
Height of the thrust (springing)23.63 m
Buttress depth (measured)3.4 m
Buttress breadth (assumed: half the depth)1.7 m
Thrust it holds: block | cracked236 | 79 kN
Minimum depth: block | cracked1.9 | 2.74 m
GSF on depth: block | cracked1.79 | 1.24
Fracture height23.63 m
1890: base joint, eccentricity ÷ kern0.52

Assumptions

  • Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
  • In a basilica the outer buttress takes the nave vault’s thrust through the flyers; the aisle vault is left out.
  • Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).

How the modern check works →

Plates

Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.

Sources

Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.