Skip to content
Ungewitter

← All reference buildings

Salisbury Cathedral

Salisbury · Kathedrale von Salisbury · Wikidata Q390150

6 measured · 3 published · 7 provisional

English Early Gothic: low and long, with two transepts and a straight east end; thick walls rather than tall flyers.

Facts

Main building campaign
1220–1258 provisionalen Wikipedia, revision 1386008584Consecrated 1258; de gives completion in 1266.
Plan type
Basilica, 3 vessels, with transept provisionalde Wikipedia, revision 270028590
Material
stone provisionalen Wikipedia, revision 1386008584en: grey Chilmark stone; Purbeck marble columns.
Choir ending
flat east end provisionalde Wikipedia, revision 270028590
Towers
Crossing tower with a spire of 123 m (404 ft). provisionalde Wikipedia, revision 270028590
Vaults
Nave: quadripartite publishedDehio & von Bezold, Tafel 424, Fig. 2The crossing has a tierceron vault with a central ring.
East end
flat east end, no ambulatory publishedDehio & von Bezold, Tafel 424, Fig. 2A square retrochoir and a projecting rectangular east chapel.
Towers in plan
no west tower, a crossing tower provisionalde Wikipedia, revision 270028590A screen front without towers; the crossing tower with its spire.
Flying buttresses
one tier publishedDehio & von Bezold, Tafel 430, Fig. 2

Dimensions

DimensionsValueConventionSource
Nave width12.06 m ± 0.3 maxis to axismeasuredDehio & von Bezold, Tafel 424, Fig. 2measured from (1444.5, 1962) to (1597, 1962) px; scale 10 m = 126.5 px

Nave piers, axis to axis. Calibrated on the Canterbury scale bar of the same plate. No open source gives the nave width; de gives 23.4 m for nave and aisles together.

Aisle widths6.25 m ± 0.2 mAisle, pier axis to inner face of the wallaxis to axismeasuredDehio & von Bezold, Tafel 424, Fig. 2measured from (1365.5, 1962) to (1444.5, 1962) px; scale 10 m = 126.5 px
Bay length6.46 m ± 0.15 maxis to axismeasuredDehio & von Bezold, Tafel 424, Fig. 2measured from (1445, 1882) to (1445, 2045.5) px; scale 10 m = 126.5 px · over 2 bays

Nave pier axes over 2 bays.

Nave vault height25.5 mto the crownprovisionalde Wikipedia, revision 270028590

de: at most 25.5 m, after U. Engel, Architektur der Gotik in England.

Piers1.58 m ± 0.2 mNave pier across the shaftsoverallmeasuredDehio & von Bezold, Tafel 424, Fig. 2measured from (1434.5, 1962) to (1454.5, 1962) px; scale 10 m = 126.5 px
Buttress depths3.4 m ± 0.2 mNave buttress, outer face to inner face of the aisle walloverallmeasuredDehio & von Bezold, Tafel 424, Fig. 2measured from (1322.5, 1962) to (1365.5, 1962) px; scale 10 m = 126.5 px
Wall thicknesses1.5 m ± 0.2 mAisle wall between the buttressesoverallmeasuredDehio & von Bezold, Tafel 424, Fig. 2measured from (1346.5, 1920) to (1365.5, 1920) px; scale 10 m = 126.5 px

The design in plan

Plan of the design made from Salisbury Cathedral: quadripartite nave vaults, flat east end, no ambulatory.010 m
The Studio design made from the values on this page, drawn by the Studio’s own generators: cut masonry black, vault ribs dashed overhead. It is a design after the building, not a survey of it.

One bay in plan, to scale

Plan of one bay of Salisbury Cathedral: nave 12.06 m between pier axes, buttress depth 3.4 m; dashed outline of Amiens Cathedral for comparison.12.06 m3.4 m010 m
Drawn from the values above: nave piers, aisles, outer wall and buttresses of one bay. Buttress breadth is schematic. The dashed outline is Amiens Cathedral at the same scale.

As a design

The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave quadripartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.

Measured against the 1890 statics and the modern check

The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.

Measured against the 1890 statics and the modern check
QuantityBuilding, measuredUngewitter 1890, staticsModern check (Heyman)
Depth of wall and buttress3.4 m measured2.33 m2.4 m
Building ÷ this depth–1.461.42
Kern rule of 1890kern keptkern left in the storm only (with wind from the left)kern left in the storm only (with wind from the left)
Geometric factor, cracked2.92 against 2: safe0.97 against 1: fails1 against 1: safe
Pier (1890 plan rule)1.58 m1.64 m–
Wall between the buttresses (1890 plan rule)1.5 m1.16 m–

Forces at the springing of the nave vault, 18.48 m above the floor.

Why they differ

  • The building is deeper than the statics asks. Its buttresses stand at the foot of one tier of flyers: they had to give the flyers room, carry their thrust at its height and stand during building, before the vaults were closed. The kern rule asks only what the finished bay needs.
  • The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.

Ungewitter’s rules against this building

The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.

In a basilica the nave vault is abutted through the flying buttresses by the whole system: aisles and outer buttress together. Ungewitter’s single-span rules were never meant for it, which is the point of the comparison.

Nave vault: span 10.48 m, springing at 18.51 m

RuleFilled inRule saysBuilding hasBuilding ÷ rule
Mohrmann, rule 5D = (0.222 · 10.48 m + 0.05 · 18.51 m) · 0.876 = 2.85 m2.85 m8.86 m3.11
HoffstadtD = 10.48 m / 10 + √2 · 10.48 m / 10 = 2.53 m2.53 m8.86 m3.5
Viollet-le-DucD = 7.28 m · (1 − cos(2 · 73.7 ° / 3)) = 2.52 m2.52 m8.86 m3.52
HaseD = 2.52 m + 0.15 m · 18.51 m / 4.5 m = 3.14 m3.14 m8.86 m2.83
Earlier editionsD = (7.28 m + 0.3 m) / cos(37.2 °) − 7.28 m = 2.24 m2.24 m8.86 m3.96

Building has: whole abutment system: aisles + buttress, from the nave pier’s face

No aisle vault height is known, so the aisle vault is not checked.

Assumptions

  • Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
  • Heavy stone; no help from the walls between the buttresses.

The modern check: Heyman’s geometric factor

The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?

The buttress holds the estimated thrust, but cracked its geometric factor is only 1.25.

QuantityValue
Vault thrust per bay (estimate, Table I)40 kN
Height of the thrust (springing)18.51 m
Buttress depth (measured)3.4 m
Buttress breadth (assumed: half the depth)1.7 m
Thrust it holds: block | cracked236 | 79 kN
Minimum depth: block | cracked1.88 | 2.71 m
GSF on depth: block | cracked1.81 | 1.25
Fracture height18.51 m
1890: base joint, eccentricity ÷ kern0.51

Assumptions

  • Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
  • In a basilica the outer buttress takes the nave vault’s thrust through the flyers; the aisle vault is left out.
  • Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).

How the modern check works →

Plates

Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.

Sources

Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.