Notre-Dame de Paris
Paris · Cathédrale Notre-Dame de Paris · Wikidata Q2981
7 measured · 4 published · 10 provisional
Five vessels with galleries, sexpartite vaults: one nave bay spans two aisle bays. Early flying buttresses.
Facts
- Main building campaign
- 1163–1345 provisionalfr Wikipedia, revision 241452085
- Plan type
- Basilica, 5 vessels, with transept provisionalfr Wikipedia, revision 241452085
- Material
- stone provisionalfr Wikipedia, revision 241452085fr: Lutetian limestone of the Paris region.
- Nave bays
- 10 provisionalfr Wikipedia, revision 241452085Ten nave bays: a two-bay forebay and eight more (fr).
- Choir ending
- 5/10: 5 sides of a 10-sided polygon provisionalfr Wikipedia, revision 241452085fr: semicircular apse of five sides.
- Towers
- Two west towers of 69 m; crossing spire 96 m (fr) or 93 m (de). provisionalfr Wikipedia, revision 241452085
- Vaults
- Nave: sexpartite publishedDehio & von Bezold, Tafel 362, Fig. 2Nave and choir sexpartite.
- Vaults
- Aisles: quadripartite publishedDehio & von Bezold, Tafel 362, Fig. 2
- East end
- a double ambulatory with no radiating chapels publishedDehio & von Bezold, Tafel 362, Fig. 2A double ambulatory without radiating chapels; the shallow chapels between the buttresses (drawn on the north half) were added from about 1296.
- Towers in plan
- two west towers, a crossing tower provisionalfr Wikipedia, revision 241452085Two west towers; over the crossing a timber spire (flèche).
- Flying buttresses
- 2 tiers, one above the other publishedDehio & von Bezold, Tafel 375, Fig. 2Two tiers, each in two flights over the double aisles, landing on an intermediate pier.
- Five-aisle system
- one flyer over both aisles (pp. 289, 389) publishedLehrbuch der gotischen Konstruktionen. 3rd ed., Part I · p. 289The book names Paris for one flyer spanning both aisles (system 1). The atlas section (flyer_tiers) draws flights landing on an intermediate pier; the Studio follows the book.
Dimensions
| Dimensions | Value | Convention | Source |
|---|---|---|---|
| Nave width | 13.74 m ± 0.2 m | axis to axismeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (769, 1415.5) to (769, 1589.5) px; scale 40 m = 506.5 px Nave piers, axis to axis. The plate gives 12.3 m clear between the columns, close to the 12 m of fr. Other figures
|
| Aisle widths | 5.53 m ± 0.2 mInner aisle, pier axis to pier axis | axis to axismeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (769, 1589.5) to (769, 1659.5) px; scale 40 m = 506.5 px |
| 5.53 m ± 0.2 mOuter aisle, pier axis to inner face of the wall | axis to axismeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (769, 1659.5) to (769, 1729.5) px; scale 40 m = 506.5 px | |
| Bay length | 5.6 m ± 0.05 m | axis to axismeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (627, 1415) to (981.5, 1415) px; scale 40 m = 506.5 px · over 5 bays Nave pier axes over 5 bays (half a sexpartite vault each). |
| Nave vault height | 33 m | to the crownprovisional | fr Wikipedia, revision 241452085 fr dimension list (sources: ndparis.free.fr, notredamedeparis.fr). Other figures
|
| Aisle vault heights | 10.5 m | to the crownprovisional | fr Wikipedia, revision 241452085 Inner aisle (fr). |
| 10.1 m | to the crownprovisional | fr Wikipedia, revision 241452085 Outer aisle (fr). | |
| Piers | 1.5 m ± 0.2 mNave column, diameter | overallmeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (759.5, 1415) to (778.5, 1415) px; scale 40 m = 506.5 px |
| Buttress depths | 4.9 m ± 0.2 mNave buttress, outer face to inner face of the outer aisle wall | overallmeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (769, 1729.5) to (769, 1791.5) px; scale 40 m = 506.5 px |
| Wall thicknesses | 1.66 m ± 0.2 mOuter aisle wall between the buttresses | overallmeasured | Dehio & von Bezold, Tafel 362, Fig. 2measured from (733, 1729.5) to (733, 1750.5) px; scale 40 m = 506.5 px |
The design in plan
One bay in plan, to scale
As a design
The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave sexpartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.
Measured against the 1890 statics and the modern check
The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.
| Quantity | Building, measured | Ungewitter 1890, statics | Modern check (Heyman) |
|---|---|---|---|
| Depth of wall and buttress | 4.9 m measured | 2.65 m | 2.98 m |
| Building ÷ this depth | – | 1.85 | 1.65 |
| Kern rule of 1890 | kern kept | kern left in the storm only (with wind from the left) | kern left in the storm only (with wind from the left) |
| Geometric factor, cracked | 3.3 against 2: safe | 1.78 against 2: stands, small margin | 2 against 2: safe |
| Pier (1890 plan rule) | 1.5 m | 1.87 m | – |
| Wall between the buttresses (1890 plan rule) | 1.66 m | 1.36 m | – |
Forces at the springing of the nave vault, 24.8 m above the floor.
Why they differ
- The building is deeper than the statics asks. Its buttresses stand at the foot of 2 tiers of flyers: they had to give the flyers room, carry their thrust at its height and stand during building, before the vaults were closed. The kern rule asks only what the finished bay needs.
- The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.
Ungewitter’s rules against this building
The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.
In a basilica the nave vault is abutted through the flying buttresses by the whole system: aisles and outer buttress together. Ungewitter’s single-span rules were never meant for it, which is the point of the comparison.
Nave vault: span 12.24 m, springing at 24.84 m
| Rule | Filled in | Rule says | Building has | Building ÷ rule |
|---|---|---|---|---|
| Mohrmann, rule 5 | D = (0.222 · 12.24 m + 0.05 · 24.84 m) · 0.85 = 3.37 m | 3.37 m | 15.21 m | 4.52 |
| Hoffstadt | D = 12.24 m / 10 + √2 · 12.24 m / 10 = 2.95 m | 2.95 m | 15.21 m | 5.15 |
| Viollet-le-Duc | D = 8.5 m · (1 − cos(2 · 73.7 ° / 3)) = 2.94 m | 2.94 m | 15.21 m | 5.17 |
| Hase | D = 2.94 m + 0.15 m · 24.84 m / 4.5 m = 3.77 m | 3.77 m | 15.21 m | 4.04 |
| Earlier editions | D = (8.5 m + 0.3 m) / cos(37.2 °) − 8.5 m = 2.54 m | 2.54 m | 15.21 m | 5.99 |
Building has: whole abutment system: aisles + buttress, from the nave pier’s face
Outer aisle vault: span 4.78 m, springing at 6.91 m
| Rule | Filled in | Rule says | Building has | Building ÷ rule |
|---|---|---|---|---|
| Mohrmann, rule 5 | D = 0.222 · 4.78 m + 0.05 · 6.91 m + 0.25 m = 1.66 m | 1.66 m | 4.9 m | 2.96 |
| Hoffstadt | D = 4.78 m / 10 + √2 · 4.78 m / 10 = 1.15 m | 1.15 m | 4.9 m | 4.25 |
| Viollet-le-Duc | D = 3.32 m · (1 − cos(2 · 73.7 ° / 3)) = 1.15 m | 1.15 m | 4.9 m | 4.27 |
| Hase | D = 1.15 m + 0.15 m · 6.91 m / 4.5 m = 1.38 m | 1.38 m | 4.9 m | 3.55 |
| Earlier editions | D = (3.32 m + 0.3 m) / cos(37.6 °) − 3.32 m = 1.25 m | 1.25 m | 4.9 m | 3.93 |
Building has: the buttress, from the inner face of its wall
Assumptions
- Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
- Heavy stone; no help from the walls between the buttresses.
The modern check: Heyman’s geometric factor
The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?
The buttress holds the estimated thrust, but cracked its geometric factor is only 1.8.
| Quantity | Value |
|---|---|
| Vault thrust per bay (estimate, Table I) | 40 kN |
| Height of the thrust (springing) | 24.84 m |
| Buttress depth (measured) | 4.9 m |
| Buttress breadth (assumed: half the depth) | 2.45 m |
| Thrust it holds: block | cracked | 706 | 235 kN |
| Minimum depth: block | cracked | 1.89 | 2.72 m |
| GSF on depth: block | cracked | 2.6 | 1.8 |
| Fracture height | 24.84 m |
| 1890: base joint, eccentricity ÷ kern | 0.17 |
Assumptions
- Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
- In a basilica the outer buttress takes the nave vault’s thrust through the flyers; the aisle vault is left out.
- Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).
Plates
Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.
Sources
Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.
Wikipedia contributors. 2026. Dimension lists in German and French Wikipedia articles on Gothic cathedrals. Accessed November 21, 2026.
Numbers only, each with its traced book citation. Prose may not be copied (CC BY-SA share-alike).
Dehio, Georg, and Gustav von Bezold. 1887–1901. Die kirchliche Baukunst des Abendlandes: Atlas. 5 vols. Stuttgart: Cotta.
Universitätsbibliothek Heidelberg (requested in the IIIF manifest)
Ungewitter, Georg Gottlob. 1890. Lehrbuch der gotischen Konstruktionen. 3rd ed., revised by Karl Mohrmann. Vol. 1. Leipzig: Weigel.
- Lehrbuch der gotischen Konstruktionen. 3rd ed., Part I · p. 289