Skip to content
Ungewitter

← All reference buildings

Noyon Cathedral

Noyon · Cathédrale Notre-Dame de Noyon · Kathedrale von Noyon · Wikidata Q932828

6 measured · 3 published · 1 derived · 9 provisional

Early Gothic gallery basilica with alternating main and intermediate piers: the bay given is a single bay, the vaulting unit a double bay of about 8.7 m. Measured on the Dehio plate at its low resolution (±0.16 m).

Facts

Main building campaign
1157–1221 provisionalde Wikipedia, revision 270585346Choir c. 1157-1164/67, nave c. 1160-1185, west front 1185-1221.
Plan type
Basilica, 3 vessels, with transept provisionalde Wikipedia, revision 270585346Three-aisled gallery basilica on cross plan.
Material
stone provisionalfr Wikipedia, revision 240713763fr: Lutetian limestone from near the town.
Nave bays
10 derivedDehio & von Bezold, Tafel 361, Fig. 1Single bays between crossing and west block, counted on the plan; main and intermediate piers alternate, so five double bays.
Choir ending
5 sides provisionalfr Wikipedia, revision 240713763fr: five-sided apse with ambulatory and five radiating chapels; the polygon is not stated.
Towers
West towers 62 m (de); north tower 66 m (fr, en infobox); spires never built. provisionalfr Wikipedia, revision 240713763
Vaults
Nave: sexpartite provisionalDehio & von Bezold, Tafel 361, Fig. 1Read as sexpartite: diagonals over double bays crossing at the minor columns. The nave vaults were repaired after the fire of 1293.
Vaults
Aisles: quadripartite publishedDehio & von Bezold, Tafel 361, Fig. 1
East end
an ambulatory with 5 radiating chapels publishedDehio & von Bezold, Tafel 361, Fig. 1One ambulatory with five radiating chapels that merge into one another.
Towers in plan
two west towers provisionalDehio & von Bezold, Tafel 361, Fig. 1Two west towers behind a porch; the spires were never built.
Flying buttresses
one tier publishedDehio & von Bezold, Tafel 371, Fig. 3One flyer above the gallery roof; the flyers were added after the fire of 1293 (de).

Dimensions

DimensionsValueConventionSource
Nave width10.19 m ± 0.2 mMain piers of the nave, axis to axisaxis to axismeasuredDehio & von Bezold, Tafel 361, Fig. 1measured from (464.5, 984) to (596, 984) px; scale 30 m = 387 px
Other figures
Aisle widths4.73 m ± 0.2 mWest aisle, pier axis to inner face of the wallaxis to axismeasuredDehio & von Bezold, Tafel 361, Fig. 1measured from (403.5, 1012) to (464.5, 1012) px; scale 30 m = 387 px
Other figures
Bay length4.34 m ± 0.05 mNave pier axes over 6 bays (main and intermediate piers alternate)axis to axismeasuredDehio & von Bezold, Tafel 361, Fig. 1measured from (465, 873) to (465, 1209) px; scale 30 m = 387 px · over 6 bays
Nave vault height23 mto the crownprovisionalde Wikipedia, revision 270585346

Vaults reach a crown height of 23 m.

Other figures
Aisle vault heights8.77 mconvention not statedprovisionalfr Wikipedia, revision 240713763

Nave aisle vaults 8.77 m; ambulatory 8 m, radiating chapels 8.10 m.

Piers1.55 m ± 0.2 mMain nave pier across the shafts, transverseoverallmeasuredDehio & von Bezold, Tafel 361, Fig. 1measured from (454.5, 984) to (474.5, 984) px; scale 30 m = 387 px
Buttress depths2.71 m ± 0.2 mNave buttress, outer face to inner face of the aisle walloverallmeasuredDehio & von Bezold, Tafel 361, Fig. 1measured from (368.5, 984) to (403.5, 984) px; scale 30 m = 387 px
Wall thicknesses0.93 m ± 0.2 mAisle wall between the buttressesoverallmeasuredDehio & von Bezold, Tafel 361, Fig. 1measured from (391.5, 1012) to (403.5, 1012) px; scale 30 m = 387 px

The design in plan

Plan of the design made from Noyon Cathedral: sexpartite nave vaults, an ambulatory with 5 radiating chapels.010 m
The Studio design made from the values on this page, drawn by the Studio’s own generators: cut masonry black, vault ribs dashed overhead. It is a design after the building, not a survey of it. The east end comes from the chevet generator (Ch. VI), which draws the church with one aisle on each side.

One bay in plan, to scale

Plan of one bay of Noyon Cathedral: nave 10.19 m between pier axes, buttress depth 2.71 m; dashed outline of Amiens Cathedral for comparison.10.19 m2.71 m010 m
Drawn from the values above: nave piers, aisles, outer wall and buttresses of one bay. Buttress breadth is schematic. The dashed outline is Amiens Cathedral at the same scale.

As a design

The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave sexpartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.

Measured against the 1890 statics and the modern check

The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.

Measured against the 1890 statics and the modern check
QuantityBuilding, measuredUngewitter 1890, staticsModern check (Heyman)
Depth of wall and buttress2.71 m measured2.03 m2.23 m
Building ÷ this depth–1.331.21
Kern rule of 1890kern left in the storm only (with wind from the left)kern left in the storm only (with wind from the left)kern left in the storm only (with wind from the left)
Geometric factor, cracked1.21 against 1: safe0.91 against 1: fails1 against 1: safe
Pier (1890 plan rule)1.55 m1.38 m–
Wall between the buttresses (1890 plan rule)0.93 m0.96 m–

Forces at the springing of the nave vault, 17.21 m above the floor.

Why they differ

  • The building is deeper than the statics asks. Its buttresses stand at the foot of one tier of flyers: they had to give the flyers room, carry their thrust at its height and stand during building, before the vaults were closed. The kern rule asks only what the finished bay needs.
  • The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.

Ungewitter’s rules against this building

The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.

In a basilica the nave vault is abutted through the flying buttresses by the whole system: aisles and outer buttress together. Ungewitter’s single-span rules were never meant for it, which is the point of the comparison.

Nave vault: span 8.64 m, springing at 17.24 m

RuleFilled inRule saysBuilding hasBuilding ÷ rule
Mohrmann, rule 5D = (0.222 · 8.64 m + 0.05 · 17.24 m) · 0.851 = 2.37 m2.37 m6.67 m2.82
HoffstadtD = 8.64 m / 10 + √2 · 8.64 m / 10 = 2.09 m2.09 m6.67 m3.2
Viollet-le-DucD = 6 m · (1 − cos(2 · 73.7 ° / 3)) = 2.08 m2.08 m6.67 m3.21
HaseD = 2.08 m + 0.15 m · 17.24 m / 4.5 m = 2.65 m2.65 m6.67 m2.51
Earlier editionsD = (6 m + 0.3 m) / cos(37.3 °) − 6 m = 1.92 m1.92 m6.67 m3.48

Building has: whole abutment system: aisles + buttress, from the nave pier’s face

Outer aisle vault: span 3.96 m, springing at 6.13 m

RuleFilled inRule saysBuilding hasBuilding ÷ rule
Mohrmann, rule 5D = 0.222 · 3.96 m + 0.05 · 6.13 m + 0.25 m = 1.44 m1.44 m2.71 m1.89
HoffstadtD = 3.96 m / 10 + √2 · 3.96 m / 10 = 0.95 m0.95 m2.71 m2.84
Viollet-le-DucD = 2.75 m · (1 − cos(2 · 73.7 ° / 3)) = 0.95 m0.95 m2.71 m2.85
HaseD = 0.95 m + 0.15 m · 6.13 m / 4.5 m = 1.15 m1.15 m2.71 m2.35
Earlier editionsD = (2.75 m + 0.3 m) / cos(37.7 °) − 2.75 m = 1.1 m1.1 m2.71 m2.46

Building has: the buttress, from the inner face of its wall

Assumptions

  • Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
  • Heavy stone; no help from the walls between the buttresses.

The modern check: Heyman’s geometric factor

The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?

The buttress holds the estimated thrust, but cracked its geometric factor is only 1.22.

QuantityValue
Vault thrust per bay (estimate, Table I)22 kN
Height of the thrust (springing)17.24 m
Buttress depth (measured)2.71 m
Buttress breadth (assumed: half the depth)1.36 m
Thrust it holds: block | cracked119 | 40 kN
Minimum depth: block | cracked1.54 | 2.23 m
GSF on depth: block | cracked1.76 | 1.22
Fracture height17.24 m
1890: base joint, eccentricity ÷ kern0.55

Assumptions

  • Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
  • In a basilica the outer buttress takes the nave vault’s thrust through the flyers; the aisle vault is left out.
  • Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).

How the modern check works →

Plates

Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.

Sources

Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.