St Elizabeth’s Church, Marburg
Marburg · Elisabethkirche · Elisabethkirche Marburg · Wikidata Q695891
6 measured · 3 published · 1 derived · 8 provisional
One of the first Gothic hall churches in Germany, begun 1235 over the grave of St Elizabeth: three vessels of equal height under one roof, with a trefoil east end of three 5/10 conches. In a hall the nave vault leans on the aisle vaults, so the check takes the outer aisle against its buttress, as Ungewitter does in his hall-church example.
Facts
- Main building campaign
- 1235–1283 provisionalde Wikipedia, revision 272270293Begun 1235 (foundation probably 14 Aug); consecrated 1283 without tower tops.
- Plan type
- Hall church, 3 vessels, with transept provisionalde Wikipedia, revision 272270293Three-aisled hall church with trefoil (three-conch) choir, cruciform plan.
- Hall
- aisles as high as the nave provisionalde Wikipedia, revision 272270293All three vessels reach 20.50 m vault height.
- Material
- stone provisionalde Wikipedia, revision 272270293de: red Marburg sandstone from a quarry near Wehrda.
- Nave bays
- 6 provisionalde Wikipedia, revision 272270293Six transverse-rectangular nave bays, rib-vaulted.
- Choir ending
- 5/10: 5 sides of a 10-sided polygon provisionalde Wikipedia, revision 272270293Each conch: one fore-bay ending in half a decagon; after Dehio, Hessen I (2008), p. 614.
- Towers
- Two west towers, about 80 m. provisionalde Wikipedia, revision 272270293
- Vaults
- Nave: quadripartite publishedDehio & von Bezold, Tafel 453, Fig. 1
- East end
- apse, no ambulatory publishedDehio & von Bezold, Tafel 453, Fig. 1A trefoil: choir and both transept arms end in 5/10 apses.
- Towers in plan
- two west towers publishedDehio & von Bezold, Tafel 453, Fig. 1
- Flying buttresses
- none derivedDehio & von Bezold, Tafel 453, Fig. 1A hall church: the aisle vaults abut the nave at its own height, so there are no flying buttresses.
Dimensions
| Dimensions | Value | Convention | Source |
|---|---|---|---|
| Nave width | 10.33 m ± 0.1 mNave piers, axis to axis | axis to axismeasured | Dehio & von Bezold, Tafel 453, Fig. 1measured from (1313, 1006.5) to (1313, 1315) px; scale 20 m = 597.5 px |
| Aisle widths | 5.36 m ± 0.1 mAisle, pier axis to inner face of the wall | axis to axismeasured | Dehio & von Bezold, Tafel 453, Fig. 1measured from (1313, 846.5) to (1313, 1006.5) px; scale 20 m = 597.5 px |
| Bay length | 4.95 m ± 0.05 mNave pier axes over 4 bays | axis to axismeasured | Dehio & von Bezold, Tafel 453, Fig. 1measured from (1018, 1003) to (1610, 1003) px; scale 20 m = 597.5 px · over 4 bays |
| Nave vault height | 20.5 m | convention not statedprovisional | de Wikipedia, revision 272270293 Vault height of each of the three vessels. Other figures
|
| Aisle vault heights | 20.5 m | convention not statedprovisional | de Wikipedia, revision 272270293 Aisles same height as nave (hall). |
| Piers | 2.21 m ± 0.1 mNave pier across the shafts, transverse | overallmeasured | Dehio & von Bezold, Tafel 453, Fig. 1measured from (1313, 973.5) to (1313, 1039.5) px; scale 20 m = 597.5 px |
| Buttress depths | 2.24 m ± 0.1 mButtress (pierced by the wall passage), outer face to inner face of the wall | overallmeasured | Dehio & von Bezold, Tafel 453, Fig. 1measured from (1313, 779.5) to (1313, 846.5) px; scale 20 m = 597.5 px |
| Wall thicknesses | 0.74 m ± 0.1 mAisle wall between the buttresses | overallmeasured | Dehio & von Bezold, Tafel 453, Fig. 1measured from (1240, 824.5) to (1240, 846.5) px; scale 20 m = 597.5 px |
The design in plan
One bay in plan, to scale
As a design
The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave quadripartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.
Measured against the 1890 statics and the modern check
The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.
| Quantity | Building, measured | Ungewitter 1890, statics | Modern check (Heyman) |
|---|---|---|---|
| Depth of wall and buttress | 2.24 m measured | 2.32 m | 2.51 m |
| Building ÷ this depth | – | 0.96 | 0.89 |
| Kern rule of 1890 | edge pressure too high (with wind from the left) | kern left in the storm only (with wind from the left) | kern left in the storm only (with wind from the left) |
| Geometric factor, cracked | 0.88 against 1: fails | 0.93 against 1: fails | 1 against 1: safe |
| Pier (1890 plan rule) | 2.21 m | 0.41 m | – |
| Wall between the buttresses (1890 plan rule) | 0.74 m | 0.9 m | – |
Forces at the springing of the nave vault, 15.06 m above the floor.
Why they differ
- The measured depth lies within 10 % of the depth the 1890 statics asks for: the book’s kern rule describes this buttress well.
- The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.
Ungewitter’s rules against this building
The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.
A hall church: nave and aisle vaults spring at about the same height and lean on one another, so only the outer aisle vault presses on the buttresses. The rules are applied to it, as in Ungewitter’s own hall-church example.
Outer aisle vault: span 4.26 m, springing at 17.66 m
| Rule | Filled in | Rule says | Building has | Building ÷ rule |
|---|---|---|---|---|
| Mohrmann, rule 5 | D = 0.222 · 4.26 m + 0.05 · 17.66 m + 0.25 m = 2.08 m | 2.08 m | 2.24 m | 1.08 |
| Hoffstadt | D = 4.26 m / 10 + √2 · 4.26 m / 10 = 1.03 m | 1.03 m | 2.24 m | 2.18 |
| Viollet-le-Duc | D = 2.95 m · (1 − cos(2 · 73.7 ° / 3)) = 1.02 m | 1.02 m | 2.24 m | 2.19 |
| Hase | D = 1.02 m + 0.15 m · 17.66 m / 4.5 m = 1.61 m | 1.61 m | 2.24 m | 1.39 |
| Earlier editions | D = (2.95 m + 0.3 m) / cos(37.6 °) − 2.95 m = 1.16 m | 1.16 m | 2.24 m | 1.94 |
Building has: the buttress, from the inner face of its wall
Assumptions
- Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
- Heavy stone; no help from the walls between the buttresses.
The modern check: Heyman’s geometric factor
The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?
The buttress holds the estimated thrust, but cracked its geometric factor is only 1.58.
| Quantity | Value |
|---|---|
| Vault thrust per bay (estimate, Table I) | 12 kN |
| Vault load on the buttress (estimate, Table I) | 39 kN |
| Height of the thrust (springing) | 17.66 m |
| Buttress depth (measured) | 2.24 m |
| Buttress breadth (assumed: half the depth) | 1.12 m |
| Thrust it holds: block | cracked | 72 | 37 kN |
| Minimum depth: block | cracked | 1.18 | 1.42 m |
| GSF on depth: block | cracked | 1.9 | 1.58 |
| Fracture height | 13.74 m |
| 1890: base joint, eccentricity ÷ kern | 0.42 |
Assumptions
- Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
- A hall church: the outer aisle vault is taken (its span and crown), with its vertical load on the wall and buttress.
- Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).
Plates
Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.
Sources
Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.
Wikipedia contributors. 2026. Dimension lists in German and French Wikipedia articles on Gothic cathedrals. Accessed November 21, 2026.
Numbers only, each with its traced book citation. Prose may not be copied (CC BY-SA share-alike).
Dehio, Georg, and Gustav von Bezold. 1887–1901. Die kirchliche Baukunst des Abendlandes: Atlas. 5 vols. Stuttgart: Cotta.
Universitätsbibliothek Heidelberg (requested in the IIIF manifest)