Skip to content
Ungewitter

← All reference buildings

Cologne Cathedral

Cologne · Hohe Domkirche St. Petrus · Kölner Dom · Wikidata Q4176

8 measured · 3 published · 8 provisional

German High Gothic after Amiens, with double flying buttresses; slimmer piers than Amiens (crossing pier 3.52 m² against 4.52 m², Wolff).

Facts

Main building campaign
1248–1880 provisionalde Wikipedia, revision 271917040Choir 1248–1322; building stopped around 1560 and was completed 1842–1880.
Plan type
Basilica, 5 vessels, with transept provisionalde Wikipedia, revision 271917040
Material
stone provisionalen Wikipedia, revision 1386060549en: sandstone was used from 1842 for the transept fronts and the upper nave.
Choir ending
7/12: 7 sides of a 12-sided polygon provisionalde Wikipedia, revision 271917040The chapels form seven parts of a regular twelve-sided figure (de).
Towers
Two west towers of about 157 m; crossing tower 109 m. provisionalde Wikipedia, revision 271917040
Vaults
Nave: quadripartite publishedDehio & von Bezold, Tafel 363, Fig. 4
East end
an ambulatory with 7 radiating chapels publishedDehio & von Bezold, Tafel 363, Fig. 4Seven radiating chapels.
Towers in plan
two west towers, a crossing tower provisionalde Wikipedia, revision 271917040Two west towers; the crossing tower of 109 m is a ridge turret.
Flying buttresses
2 tiers, one above the other publishedDehio & von Bezold, Tafel 463, Fig. 2Two tiers, each in two flights over the double aisles.
Five-aisle system
flyers in two spans over an intermediate pier (pp. 289, 389–390) publishedLehrbuch der gotischen Konstruktionen. 3rd ed., Part II · p. 413Flyers in two spans over an intermediate pier, the usual way (p. 289); p. 413 describes Cologne’s intermediate piers on a Greek-cross plan with pinnacles.

Dimensions

DimensionsValueConventionSource
Nave width15.19 m ± 0.2 maxis to axismeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3903, 1612) to (4093.5, 1612) px; scale 50 m = 627 px

Nave piers, axis to axis. Bays and widths on this figure run about 4 % above the published 7.50 m bay; the plate’s scale bar may be drawn short.

Other figures
  • 12.5 m · convention not stated provisionalde Wikipedia, revision 271917040 · p. 83de: “Weite 12,50 m”, after K. G. Beuckers, Der Kölner Dom (2004), p. 83. Probably clear: the plate gives 12.9 m between the piers.
Aisle widths8.13 m ± 0.2 mInner aisle, pier axis to pier axisaxis to axismeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3801, 1612) to (3903, 1612) px; scale 50 m = 627 px
6.82 m ± 0.2 mOuter aisle, pier axis to inner face of the wallaxis to axismeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3715.5, 1612) to (3801, 1612) px; scale 50 m = 627 px
Bay length7.79 m ± 0.1 maxis to axismeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3903, 1417.5) to (3903, 1710.5) px; scale 50 m = 627 px · over 3 bays

Nave pier axes over 3 bays.

Other figures
Nave vault height43.35 mto the crownprovisionalde Wikipedia, revision 271917040

de (“Der Dom in Zahlen”, koelner-dom.de) and en.

Aisle vault heights19.8 mto the crownprovisionalde Wikipedia, revision 271917040

de (“Der Dom in Zahlen”).

Other figures
Piers2.31 m ± 0.2 mNave pier across the shafts, transverseoverallmeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3888.5, 1612) to (3917.5, 1612) px; scale 50 m = 627 px
Other figures
  • 2.13 m · convention not stated provisionalde Wikipedia, revision 271917040 · after Arnold Wolff, p. 35After A. Wolff, Die vollkommene Kathedrale, p. 35 (diameters 1.92 and 2.13 m).
1.83 m ± 0.2 mNave pier across the shafts, longitudinaloverallmeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3903, 1601.5) to (3903, 1624.5) px; scale 50 m = 627 px
Other figures
Buttress depths5.02 m ± 0.2 mNave buttress, outer face to inner face of the outer aisle walloverallmeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3652.5, 1612) to (3715.5, 1612) px; scale 50 m = 627 px
Wall thicknesses1.67 m ± 0.2 mOuter aisle wall between the buttressesoverallmeasuredDehio & von Bezold, Tafel 363, Fig. 4measured from (3694.5, 1650) to (3715.5, 1650) px; scale 50 m = 627 px

The design in plan

Plan of the design made from Cologne Cathedral: quadripartite nave vaults, an ambulatory with 7 radiating chapels.010 m
The Studio design made from the values on this page, drawn by the Studio’s own generators: cut masonry black, vault ribs dashed overhead. It is a design after the building, not a survey of it. The east end comes from the chevet generator (Ch. VI), which draws the church with one aisle on each side. The church has two aisles on each side; the drawing shows the inner one.

One bay in plan, to scale

Plan of one bay of Cologne Cathedral: nave 15.19 m between pier axes, buttress depth 5.02 m; dashed outline of Amiens Cathedral for comparison.15.19 m5.02 m010 m
Drawn from the values above: nave piers, aisles, outer wall and buttresses of one bay. Buttress breadth is schematic. The dashed outline is Amiens Cathedral at the same scale.

As a design

The measured values as a Studio design: vessels, nave width, aisle and bay ratios, nave bays, choir ending and transept, the springings (measured, or the vault crown less a rise of 2:3 over the clear span), the piers and the material. The recorded facts above, each with its source, give the vault types (the nave quadripartite), the chevet, the towers and the tiers of flyers; the building’s date sets the period of its tracery and portals. Everything else keeps the Studio’s defaults.

Measured against the 1890 statics and the modern check

The design is sized twice at its typical nave bay: by the 1890 statics (the least depth of wall and buttress that keeps the line of pressure in the kern) and by the modern check (Heyman: the least depth with a geometric factor of 2). The depth measured on the plate is then checked with the same forces by both criteria, so all three columns are judged alike.

Measured against the 1890 statics and the modern check
QuantityBuilding, measuredUngewitter 1890, staticsModern check (Heyman)
Depth of wall and buttress5.02 m measured3.18 m3.18 m
Building ÷ this depth–1.581.58
Kern rule of 1890kern keptkern left in the storm only (with wind from the left)kern left in the storm only (with wind from the left)
Geometric factor, cracked1.66 against 1: safe1.03 against 1: safe1.03 against 1: safe
Pier (1890 plan rule)2.31 m2.06 m–
Wall between the buttresses (1890 plan rule)1.67 m1.43 m–

Forces at the springing of the nave vault, 34.72 m above the floor.

Why they differ

  • The building is deeper than the statics asks. Its buttresses stand at the foot of 2 tiers of flyers: they had to give the flyers room, carry their thrust at its height and stand during building, before the vaults were closed. The kern rule asks only what the finished bay needs.
  • The check is drawn in one plane: one typical bay of the nave, the buttress breadth taken as a share of its depth, the wall as measured where known. Real buttresses vary along the church.

Ungewitter’s rules against this building

The rules of experience reported by Ungewitter and Mohrmann (1890, pp. 273–276) size the abutment of one vault span. Here they are applied to this building’s spans and heights and set against the buttresses measured on the plate.

In a basilica the nave vault is abutted through the flying buttresses by the whole system: aisles and outer buttress together. Ungewitter’s single-span rules were never meant for it, which is the point of the comparison.

Nave vault: span 12.88 m, springing at 34.76 m

RuleFilled inRule saysBuilding hasBuilding ÷ rule
Mohrmann, rule 5D = (0.222 · 12.88 m + 0.05 · 34.76 m) · 0.873 = 4.02 m4.02 m18.81 m4.68
HoffstadtD = 12.88 m / 10 + √2 · 12.88 m / 10 = 3.11 m3.11 m18.81 m6.05
Viollet-le-DucD = 8.94 m · (1 − cos(2 · 73.7 ° / 3)) = 3.1 m3.1 m18.81 m6.08
HaseD = 3.1 m + 0.15 m · 34.76 m / 4.5 m = 4.25 m4.25 m18.81 m4.42
Earlier editionsD = (8.94 m + 0.3 m) / cos(37.1 °) − 8.94 m = 2.65 m2.65 m18.81 m7.09

Building has: whole abutment system: aisles + buttress, from the nave pier’s face

Outer aisle vault: span 5.67 m, springing at 16.02 m

RuleFilled inRule saysBuilding hasBuilding ÷ rule
Mohrmann, rule 5D = 0.222 · 5.67 m + 0.05 · 16.02 m = 2.06 m2.06 m5.02 m2.44
HoffstadtD = 5.67 m / 10 + √2 · 5.67 m / 10 = 1.37 m1.37 m5.02 m3.67
Viollet-le-DucD = 3.93 m · (1 − cos(2 · 73.7 ° / 3)) = 1.36 m1.36 m5.02 m3.69
HaseD = 1.36 m + 0.15 m · 16.02 m / 4.5 m = 1.9 m1.9 m5.02 m2.65
Earlier editionsD = (3.93 m + 0.3 m) / cos(37.5 °) − 3.93 m = 1.4 m1.4 m5.02 m3.59

Building has: the buttress, from the inner face of its wall

Assumptions

  • Vault rise 2/3 of the span (a low pointed arch); springing height = vault height − rise.
  • Heavy stone; no help from the walls between the buttresses.

The modern check: Heyman’s geometric factor

The rules above size a buttress by proportion. Here the measured buttress is checked by limit analysis against an estimate of the vault’s thrust: how much shallower could it be before it overturns, as one block and once cracked?

The buttress holds the estimated thrust, but cracked its geometric factor is only 1.62.

QuantityValue
Vault thrust per bay (estimate, Table I)59 kN
Height of the thrust (springing)34.76 m
Buttress depth (measured)5.02 m
Buttress breadth (assumed: half the depth)2.51 m
Thrust it holds: block | cracked759 | 253 kN
Minimum depth: block | cracked2.14 | 3.09 m
GSF on depth: block | cracked2.34 | 1.62
Fracture height34.76 m
1890: base joint, eccentricity ÷ kern0.23

Assumptions

  • Estimates: quadripartite vault, rise 2/3 of the span, Table I (mean H₀); ashlar 24 kN/m³; the thrust acts on the inner face at the springing; buttress breadth half its depth; the masonry above the springing (pinnacles) is ignored, which is conservative.
  • In a basilica the outer buttress takes the nave vault’s thrust through the flyers; the aisle vault is left out.
  • Cracked buttress after Ochsendorf (2002) and Ochsendorf, Hernando & Huerta (2004): a straight fracture from the toe, its height from the published equations (checked against both worked examples).

How the modern check works →

Plates

Public-domain plates of this building in Dehio and von Bezold’s atlas. Open them in the Heidelberg viewer or measure them with tools/plate-digitiser.

Sources

Every work this page cites, with the plates and article revisions it uses. The plates of Dehio and von Bezold are in the public domain; Wikipedia articles serve as pointers, each fixed to its revision.